Angelcare AC601 Manuel du propriétaire télécharger pdf (Page 10)

Testing Your Monitor

Always test your monitor before using it the first time and then on a periodic basis. Before testing your

monitor, complete the setup process as described above.

TESTING THE MOVEMENT FUNCTION

Note: Make Sure your Sensor Pad is set up before proceeding with this section. If you haven't set up your

Sensor Pad please go to page 5 for instructions on how to properly set up the Sensor Pad.

Make sure the Sensor Pad's cord is plugged into the Nursery Unit.

Switch the Nursery Unit to the "Sound /

Movement" function

. Turn the Parent Unit ON and select either channel A, B or C. Make sure it is set to the

same channel as the Nursery Unit. The green power indicator light will light up. Gently pat your hand on the

mattress. The green Movement Indicator light on the Nursery Unit will flash continuously.

Remove your hand from the mattress. Due to the lack of movement, the Movement Indicator light will stop

flashing, and a pre-alarm beep will sound after 15 seconds. Five seconds later the alarm will sound, the green

Alarm Indicator Light on the Nursery Unit will flash continuously and the green lights on the Parent Unit will

also flash continuously.

IMPORTANT: If the alarm does not sound when you are not touching the mattress, the Sensor Pad may be

detecting a continuous vibration from another source from inside and/or outside your baby's room. Common

sources of this interference are crib mobiles, fans, washing machines or even loud music. Therefore, it is very

important to make sure all vibration sources are eliminated before using the monitor.

Place the crib near a solid supporting wall and away from strong air currents. Do not use crib mobiles or acces-

sories that may cause vibrations. Avoid contact with the crib when the monitor is in use. If you find the alarm

will still not sound when you are not touching the mattress or crib, the monitor is on, and you have removed

all external sources of vibration, the sensitivity level may need to be decreased (Refer to the movement

sensitivity adjustment section on page 7).

Test the stopping of the alarm: to stop the alarm, place your hand lightly on the mattress so that the Sensor

Pad starts detecting movement again. You may also shut the Nursery Unit OFF to stop the alarm.

TESTING THE “TIC” FUNCTION

Make sure the Sensor Pad's cord is plugged into the Nursery Unit.

Switch the Nursery Unit to the "Sound /

Movement" function.

Turn the Parent Unit ON and select either channel A, B or C. Make sure it is set to the

same channel as the Nursery Unit. The green power indicator light will light up. Gently pat your hand on the

mattress. The green Movement Indicator light on the Nursery Unit will flash and you will hear the Tic sound

with every movement.

Remove your hand from the mattress. Due to the lack of movement, the ticking will stop, the Movement

Indicator light will stop flashing and a pre-alarm beep will sound after 15 seconds. Five seconds later the alarm

will sound, the green alarm indicator light on the Nursery Unit will flash continuousl and the green lights on

the Parent Unit will also flash continuously. To test the sound function, please refer to the Sound Only section

below.

The “Tic” sound will be heard when the Sound & Movement option is chosen. If you do not wish to

hear the “tic”, select “tic off” on the right wing of the Nursery Unit.

AC601 NA 13 12 2012_Layout 1 12-12-19 10:51 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Angelcare AC601 Manuel du propriétaire Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs vidéo pour bébés Angelcare AC601