Angelcare AC420 Manuel du propriétaire télécharger pdf (Page 12)

Problem Possible Cause Solution

No sound is being transmitted.

• Units are too far apart.

• Batteries are low or improperly installed.

• AC adaptors are not connected properly or

electrical outlet is out of order.

• One of the units is OFF.

• Bring Parent Unit closer to Nursery Unit.

• Check/replace batteries or recharge Parent Unit.

• Check connections or change to another electrical

outlet.

• Ensure both units are ON.

• Check the microphone sensitivity dial.

Power ON indicator (green light)

does not light up.

Display is not activated on the

Parent Unit.

• Batteries are low or improperly installed.

• AC adapters are not connected properly or electrical

outlet is out of order.

•The Nursery Unit is at OFF position (“O”).

• Check/replace batteries or recharge Parent Unit

• Check connections or change to another electrical

outlet.

• Make sure Nursery Unit is ON (Left wing on “-”

position).

Static, distortion, interference

(interference from other monitors,

wireless phones, walkie-talkies,

etc…).

• Parent Unit is out of range.

• Parent Unit is located near motorized devices, fluorescent

lights, television, etc…

• Bring units closer together.

• Activate the out of range indicator on the Nursery Unit

(left wing up).

• Rotate Parent Unit or move it away from source of inter-

ference.

Feedback (loud noises emitted from

Parent Unit).

• Units are too close to each other.

• Volume is too high on the Parent Unit.

• Move units farther apart (at least 3 meters/10 feet apart).

• Decrease volume on Parent Unit.

Very weak reception.

• Units are too far apart (out of range indicator will flash and

beep on the Parent Unit).

• One or both units are placed near a large metal mass.

• One or both units are not in the upright position.

• Batteries are low.

• Bring units closer together.

• Change the position of one or both units.

• Place units on flat surface away from baby’s reach.

• Replace the batteries in the Nursery Unit or recharge

the Parent Unit.

TROUBLESHOOTING

WATER, MOISTURE AND HEAT DAMAGE: Keep all components

away from water (sink, bath tub, swimming pool) and places that

emit heat (stove, radiator).

VENTILATION: ALWAYS place both units on a flat surface in an

upright position so that air can flow freely around them.

AC POWER SOURCE: Use only the AC adaptors supplied with the

Angelcare

Monitor.

CORD PROTECTION : Avoid damage to the adapter cords. Route

cords so that they are not likely to be walked on or pinched by

items placed on or against them.

CLEANING: Disconnect all units before cleaning. DO NOT

immerse in water. Use a dry cloth to keep monitor free from dust.

DO NOT spray with cleaning products or solvents. Wipe with a

very slightly damp cloth with an antiseptic or mild detergent.

OBJECT AND LIQUID ENTRY: Care should be taken so that

objects do not fall onto units and that liquids are not spilled into

either unit through openings.

NON-USE PERIODS: When not using the monitor for a short

period, make sure to turn the units OFF before disconnecting

them, otherwise the units will revert to the battery mode. When

not using monitor for long periods, remove the batteries from

both units and disconnect the AC adapters from electrical outlet.

Night light does not light.

• Night light is not turned ON

• Night light LED is burned

• Press on the top clear button on the Nursery Unit

• Contact your distributor.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Commentaires sur ces manuels

Pas de commentaire

Angelcare AC420 Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Moniteurs vidéo pour bébés Angelcare AC420